Solaris Topics
Oracle SPARC T4 page
SPARC T4 Getting Started Guide (PDF)
SPARC T4 Server Installation Guide (PDF)
minicom -D /dev/devicename
command from Linux (/dev/ttyUSB0
)9600 8-N-1
→
prompt, start /SYS
starts ILOM, start /HOST/console
starts pre-boot console{0} ok
prompt, typically the boot
command should workprobe-scsi-all
to list all disk infoprintenv boot-device
command shows current boot settingsetenv boot-device newbootdevspec
command to change boot devicePrepare a list of domains to search and the IP addresses of the DNS name servers on your network. Set properties in the SMF repository with the information:
$ svccfg -s network/dns/client svc:/network/dns/client> setprop config/search = astring: ("domain1" "domain2") svc:/network/dns/client> setprop config/nameserver = net_address: (address1 address2) svc:/network/dns/client> select network/dns/client:default svc:/network/dns/client:default> refresh svc:/network/dns/client:default> validate
Specify the name service switch to use DNS:
svc:/network/dns/client:default> select name-service/switch svc:/system/name-service/switch> setprop config/host = astring: "files dns" svc:/system/name-service/switch> select system/name-service/switch:default svc:/system/name-service/switch:default> refresh svc:/system/name-service/switch:default> validate svc:/system/name-service/switch:default> quit
Start the services that are needed to run the DNS client:
$ svcadm enable dns/client $ svcadm enable name-service/switch
svccfg -s system/identity:node setprop config/nodename="newhostname" svcadm refresh system/identity:node svcadm restart system/identity:node
{0} ok probe-scsi-all /pci@400/pci@2/pci@0/pci@f/pci@0/usb@0,2/hub@2/hub@3/storage@2 Unit 0 Removable Read Only device AMI Virtual CDROM 1.00 /pci@400/pci@2/pci@0/pci@4/scsi@0 FCode Version 1.00.64, MPT Version 2.00, Firmware Version 9.00.00.00 Target 9 Unit 0 Disk HITACHI H103030SCSUN300G A2A8 585937500 Blocks, 300 GB SASDeviceName 5000cca00a83c874 SASAddress 5000cca00a83c875 PhyNum 2 Target a Unit 0 Removable Read Only device TEAC DV-W28SS-V 1.0B SATA device PhyNum 6 Target b Unit 0 Disk ATA ST9500620NS SN01 976773168 Blocks, 500 GB SATAWorldWideName 5000c5002e5a1b90 PhyNum 3 /pci@400/pci@1/pci@0/pci@4/scsi@0 FCode Version 1.00.64, MPT Version 2.00, Firmware Version 9.00.00.00