User Tools

Site Tools


tech:unix:solaris:start

This is an old revision of the document!


Solaris Topics

Oracle SPARC T4 page
SPARC T4 Getting Started Guide (PDF)
SPARC T4 Server Installation Guide (PDF)

Installation & Configuration

Serial Console

  • Use the minicom -D /dev/devicename command from Linux (/dev/ttyUSB0)
  • Serial configuration: 9600 8-N-1
  • At the prompt, start /SYS starts ILOM, start /HOST/console starts pre-boot console
  • At the {0} ok prompt, typically the boot command should work
  • Use probe-scsi-all to list all disk info
  • The printenv boot-device command shows current boot setting
  • May have to use the setenv boot-device newbootdevspec command to change boot device

Trivia

Change hostname

svccfg -s system/identity:node setprop config/nodename="newhostname"
svcadm refresh system/identity:node
svcadm restart system/identity:node

Sample output ...

{0} ok probe-scsi-all
/pci@400/pci@2/pci@0/pci@f/pci@0/usb@0,2/hub@2/hub@3/storage@2
  Unit 0   Removable Read Only device    AMI     Virtual CDROM   1.00

/pci@400/pci@2/pci@0/pci@4/scsi@0

FCode Version 1.00.64, MPT Version 2.00, Firmware Version 9.00.00.00

Target 9 
  Unit 0   Disk   HITACHI  H103030SCSUN300G A2A8    585937500 Blocks, 300 GB
  SASDeviceName 5000cca00a83c874  SASAddress 5000cca00a83c875  PhyNum 2 
Target a 
  Unit 0   Removable Read Only device   TEAC     DV-W28SS-V       1.0B
  SATA device  PhyNum 6 
Target b 
  Unit 0   Disk   ATA      ST9500620NS      SN01    976773168 Blocks, 500 GB
  SATAWorldWideName 5000c5002e5a1b90  PhyNum 3 

/pci@400/pci@1/pci@0/pci@4/scsi@0

FCode Version 1.00.64, MPT Version 2.00, Firmware Version 9.00.00.00
tech/unix/solaris/start.1553318830.txt.gz · Last modified: 2019/03/23 00:27 by rk4n3