This is an old revision of the document!

Installation & Configuration

Use the minicom -D /dev/devicename command from Linux (/dev/ttyUSB0)
Serial configuration: 9600 8-N-1
At the → prompt, start /SYS starts ILOM, start /HOST/console starts pre-boot console
At the {0} ok prompt, typically the boot command should work
Use probe-scsi-all to list all disk info
The printenv boot-device command shows current boot setting
May have to use the setenv boot-device newbootdevspec command to change boot device

Trivia

svccfg -s system/identity:node setprop config/nodename="newhostname"
svcadm refresh system/identity:node
svcadm restart system/identity:node