• Use the minicom -D /dev/devicename command from Linux (/dev/ttyUSB0)
• Serial configuration: 9600 8-N-1
• The start /SYS command starts the ILOM
• The start /HOST/console command starts the pre-boot console
• At the {0} ok prompt, typically the boot command should work
• Use probe-scsi-all to list all disk info
• The printenv boot-device command shows current boot setting
• May have to use the setenv boot-device newbootdevspec command to change boot device

svccfg -s system/identity:node setprop config/nodename="newhostname"
svcadm refresh system/identity:node
svcadm restart system/identity:node